-
Welcome to H4O! For a reduced ad experience, please login or register with the forum.
-
-
KGood idea, will bleed them this weekend.
-
KKINGSKILL4U replied to the thread Yaw sensor replacement..Picked up this OBD reader for my Hummer it picks up on everything. Also, gives you recommendations for fixes as well as links to where...
-
KKINGSKILL4U replied to the thread Yaw sensor replacement..FDS was just referring to the front driver side speed sensor.
-
KKINGSKILL4U replied to the thread Yaw sensor replacement..Ok. I ran into the same issue you’re experiencing and the YAW sensor was my original thought so I went ahead and replaced it. Still...
-
KKINGSKILL4U replied to the thread Brakes.GM cleared the lights with programming the ABS module. Total cost $145 USD. No air trapped in the system. Vacuum bled is the way to...
-
Kcongrats on the 464,000 miles !!! I Hope I’m lucky enough to get that many
-
KKINGSKILL4U replied to the thread Yaw sensor replacement..Check your speed sensors at each wheel. I’ll bet one is either broken or wire has been frayed. If any have a defect traction control...
-
KKINGSKILL4U replied to the thread Brakes.Completed the work myself over the weekend.
-
KKINGSKILL4U replied to the thread Brakes.Read another thread where someone was explaining how you will receive the same lights if installing a new ABS module without it being...
-
KKINGSKILL4U replied to the thread Brakes.Again, thank you for all your help. I purchased a pneumatic bleeder kit which resolved the issue I was having. Now off to the GM...
-
KKINGSKILL4U replied to the thread Brakes.Excellent advice. Thank you for taking the time to explain. I purchased through Amazon. ACDelco GM original equipment 174-1156...
-
KKINGSKILL4U replied to the thread Brakes.Perfect! Thank you. All the while the engine is running correct? One more thing I’d like to pick your brain on if you don’t mind...
-
KKINGSKILL4U replied to the thread Brakes.Thank you for replying. Do you use the bottle method and do you pump 20-25 times per caliper or do you pump once release the pressure...
-
KHy , i do let the engine run, cause if not, you don't have all the power on break assistant ;) and bleed on all 4, by starting rear...
-
KHello, replacing the master cylinder, brake booster etc. on my 06. I’m struggling to find the correct process for bench bleeding this...
-
-
-
Loading…
-
Loading…
