axel swap?

[Jeeper360]

Looking to start gathering my parts for my solid axle swap. Of course I want to start with building the axle. When looking for my GM Dana 44, what is the desired length flange to flange that I should be looking for?

 

[cgalpha08]

Here are some build threads that have extensive information on SAS swaps:

06 H3's Squeakin H3 Build

I also installed an ARB. I first tore it apart to make sure it had the new bonded seal. Not the old style that is prone to leaking. checking for clearances. So now for KOH. Hummer performed flawlessly!! I ran Jack, blueberry, chocolate a couple times, and clawhammer. I also did...

www.hummer4x4offroad.com

CgAlpha's Solid Axle Swap - Step by step....

The following is a step-by-step how to for guys wanting to do an SAS/SOA to their H3's or H3T's. Lets get right to it... STEP 1 PREPARATIONS: The very first thing you need to do is get your rig sitting on a nice level floor slab. Good lighting, good jackstands, and some pre-measuring will...

www.hummer4x4offroad.com

 

[rascole]

Basically all GM dana 44's from early 70's to early 90's are the same width. Mine came from a 75 3/4 Sub.

 

[Jeeper360]

THAT IS WHAT I WAS LOOKING FOR
so any full-size axle will work

 

[rascole]

A GM Dana 44 from a full size, yes.

 

[Jeeper360]

I have been doing a lot of homework the oem 10bolt 30 spline might be stronger.

4speedfunk key in I am planning on getting a lot of this stuff from you!​