I installed led headlights turn signals and fog lights. The turn signal bulbs require resistors which I have two slow down the blinker to a normal rate. Has anyone else installed led (switchback) turns signals? And also installed the resistors? I am trying to figure out which wires to tap so I can install my resistors correctly. If I am not mistaken one end of the resistor taps into the ground the other into the blinker wire if I am not mistaken. Could be wrong. For those that are unfamiliar with these bulbs when in running mode the bulbs stay on a 6k white once either blinker or hazards are turned on they flash from white to bright yellow. Thanks for any help in advance
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
