H3 how to disassemble side markers on the front fenders?

[davidh3]

I want to attach roof marker wires to the side markers wires, but I had to disassemble the side markers to see how the wires are set. :huh: I want to complete [Roof Marker+Roof Light Combination] mod

Can anyone tell me how to disassemble side markers on the front fenders????

Thx:cheers:

 

[deserth3]

To get to the back of the side marker lights you have to remove the wheel well liner.

 

[alrock]

You can get to the side markers through the wheel wells. You need to remove the liners by undoing the clips that hold the liner in - pry out the center pin of the clip about 1/4", then pull the whole clip out. From there you can get to the wiring and assembly.

 

[JGBB04]

why not tap into the parking lights @ the fuse box?

 

[davidh3]

why not tap into the parking lights @ the fuse box?

Oh.. I don't know.. I just thought side markers are always on...

Any benefits I gain after tapping into the parking lights @ the fuse box?

I need to know more.:corn:

 

[JGBB04]

the side markers are part of the parking light system & it would save you taking apart the marker light, I think it's alittle easier to get to the fuse box rather than taking apart the fender well

 

[davidh3]

the side markers are part of the parking light system & it would save you taking apart the marker light, I think it's alittle easier to get to the fuse box rather than taking apart the fender well

Sounds good! I should try that way. If I fail on that, I mess with the fenders:giggle:

 

[deserth3]

Here's the instructions for installing the OEM roof marker lights. Just be carefull opening up the fuse box. The relay board is easily damaged and expensive to replace. But it is a good place to connect wiring for marker lights. They will also have their own fuse this way.
http://www.hummer4x4offroad.com/for...arker-Installation-OEM-Manual-need-it-come-in

 

[JGBB04]

 

[davidh3]

Here's the instructions for installing the OEM roof marker lights. Just be carefull opening up the fuse box. The relay board is easily damaged and expensive to replace. But it is a good place to connect wiring for marker lights. They will also have their own fuse this way.
http://www.hummer4x4offroad.com/for...arker-Installation-OEM-Manual-need-it-come-in

:corn: I posted that instruction thread.... thx anyway.

 

[deserth3]

:corn: I posted that instruction thread.... thx anyway.

I noticed that when I posted the link. Did a double take and posted it anyway for anyone else who may need it.