08 MAP sensor into 06 harness & p1134

[GoBlueHummer]

I have an 06 with an ARB snorkel that I put on a few years back. The snorkels were not made for the first design of the airbox so I did some custom plumbing to hook it all up. I have an 08 airbox that's been sitting here forever and I've finally decided to install it and hook up the snorkel properly. The MAP sensor on the 06 was bolted on top of the CAI arm off of the airbox. On the 08 the map sensor is mounted into the CAI arm. Does anyone know if I will have an issue switching the 08 style MAP sensor onto the 06 wiring harness?

Also, i recently started throwing the p1134 code which I assume will be rectified with a new O2 sensor. My H3 has 260K miles now. Is there anything I should be aware of when changing the O2 sensor and/or is there another cause to this code that I should track down.

Thanks, fellas

 

[Somethingbigandorange]

Check the wiring to the sensor and the O2 plug. Also make sure battery is good and how old are your spark plugs?

 

[GoBlueHummer]

Spark plugs are probably in the 60-70K range. I know they are supposed to roll for 100K but it probably wouldn't hurt to change those out too since you mentioned it.