Front Diff bushing gone bad

[Zach]

Finally got a chance to get my front diff out to replace the bushing. It is suppose to be a one piece bushing. Mine came out in two pieces. Bad thing is is it in pressed in and requires a J tool that no one around has. H2 specific only.
Here is what it is suppose to look like

My two piece bushing

 

[06 H3]

nice! Lol atleast its repaired now

Sent from my DROIDX using Tapatalk

 

[Zach]

nice! Lol atleast its repaired now

Sent from my DROIDX using Tapatalk

Not yet. Hopefully will be done tomorrow. Replacing the knock sensors as well so it will pass smog

 

[Scarsman]

Which bushing is that? Is that the one up on the top?

 

[Zach]

Which bushing is that? Is that the one up on the top?

It is the one on the top on the driver's side

 

[06 H3]

I am assuming this is just as serious as it is on the H3 but my bushing looked somewhat like that when I blew my front axle about a year ago...I try to stay up to date on front end bushings now...pay a little now or a lot later lol

 

[3Hummers]

Was Mike able to get you the tool?

 

[Zach]

Was Mike able to get you the tool?

No, seems no Hummer Dealer has the tool. And with Kent Moore it is on backorder till mid Feb. We are going to try to press it in.

Edit
New bushing is now in the diff.

 

[Scarsman]

You know, if I were an engineer designing a front end for an H2, I would have made all the mounts the same. What a concept, huh?

Sent from my C771 using Tapatalk

 

[M22KLARS]

Wow that thing is TRASHED! Nice work!

 

[twinmill28]

Ward, I think you were a little hard on the Beaver last night......