How hard is it to do a front differential rebuild

[Deleted member 7876]

Just like the title says. I had to get a new used front diff put in yesterday and so now I have the old one sitting around. I was just wondering how difficult it is to rebuild. I'm mechanically inclined but I've never done it before. Just curious.

Sent using smoke signals via Tapatalk

 

[Happy Hummer]

It's not as hard as you may think but it's not so easy either.
Lol! Like a government agency answer, huh?

I did the rear on my Jeep Cherokee xj and it took me quite a while.

 

[4speedfunk]

Dial calipers
Standard foot-pound torque wrench
Inch-pound torque wrench with a dial
Shop press
Hammer
Red loc-tite
Basic hand tools
YouTube
Patience

Set pinion depth
Set pinion preload
Set backlash
Check mesh pattern
Disassemble-adjust
Repeat
Repeat
Repeat
Repeat
Repeat
Install new crush sleeve
Final torque & check pattern
Fill with fluid

 

[Deleted member 7876]

Seems a bit involved, thanks.

Sent using smoke signals via Tapatalk

 

[jakesz28]

If you have to ask it might be a bit much to handle. My cast iron, electric locker build survived Moab and is quite going down the road. So it was a successful build.