Jeremy
Well-Known Member
- Messages
- 51
- Location
- Knoxville, TN
Alright, here's what's going on. Just looking for anybody who has had a similar situation and what the issue was.
My 07 Inline 5 H3 just recently started to heat up between halfway and three quarters when I come to a stop at a light or stop sign, etc. Then it will ding and the cluster says "OIL" and the red oil lamp comes on in the right corner of the cluster, under the speedometer. Then I start going again and it goes away and the temperature goes back down to halfway.
I checked the oil that was recently changed at a Valvoline and it was full and it wasn't black and it still isn't, I've been checking it every day. Then I found a leak on the top of my radiator. I patched it up with a soldering iron, put some JB Weld over that and let it dry. It still seeped out a little bit so I re-soldered it and then I put Quik Steel over that. It dried up and was hard as concrete. I drove it for a day and the Quik Steel was wet and mushy from the coolant. I scrapped it off and resoldered it AGAIN but didn't put anything over that. It leaked like a little bit one day and it doesn't seem to leak excessively anymore. It gets a little wet but I'm not losing coolant anymore. It still heats up though!!!
My 07 Inline 5 H3 just recently started to heat up between halfway and three quarters when I come to a stop at a light or stop sign, etc. Then it will ding and the cluster says "OIL" and the red oil lamp comes on in the right corner of the cluster, under the speedometer. Then I start going again and it goes away and the temperature goes back down to halfway.
I checked the oil that was recently changed at a Valvoline and it was full and it wasn't black and it still isn't, I've been checking it every day. Then I found a leak on the top of my radiator. I patched it up with a soldering iron, put some JB Weld over that and let it dry. It still seeped out a little bit so I re-soldered it and then I put Quik Steel over that. It dried up and was hard as concrete. I drove it for a day and the Quik Steel was wet and mushy from the coolant. I scrapped it off and resoldered it AGAIN but didn't put anything over that. It leaked like a little bit one day and it doesn't seem to leak excessively anymore. It gets a little wet but I'm not losing coolant anymore. It still heats up though!!!