ski.dive
Well-Known Member
- Messages
- 150
- Location
- FLORIDA + VERMONT
I need instructions to Remove the SUN-FADED H3 Plastic-Trim Pieces=So can paint them
-
Welcome to H4O! For a reduced ad experience, please login or register with the forum.
I need instructions to Remove the SUN-FADED H3 Plastic-Trim Pieces=So can paint them
- Thread starter ski.dive
- Start date
DFW Spartan
Well-Known Member
- Messages
- 125
- Location
- Dallas, TX
You can access the shop manuals at; https://schwarttzy.com/h3-hummer/
That should get you what you need.
Sent from my SM-G955U using Tapatalk
That should get you what you need.
Sent from my SM-G955U using Tapatalk
ludevick
Well-Known Member
- Messages
- 99
- Location
- Northern California
As far as I remember you’ll just need a philips head screwdriver and a t30. There’s a bolt or two at the top and then a couple song the sides.
Also I would inspect all the bolts/ screws on the roof. Loose ones can cause a pretty serious water leak inside. Trust me on that.
Also I would inspect all the bolts/ screws on the roof. Loose ones can cause a pretty serious water leak inside. Trust me on that.
mjferencak
Well-Known Member
- Messages
- 308
- Location
- Elbert, CO
If your anchor nuts spin on you, you’re going to need needle nose vise grips to keep your anchors from spinning. I had two that came loose and spun as I tried taking the windshield molding off.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk