Need Help 4x4 and Airbag Don't Work After Dash Removal

[StandoutAlpha]

Need Help 4x4 and Airbag Don't Work After Dash Removal [SOLVED]

[SOLVED] <-----------------------
**Had 2 wires mismatch and plug in wrong**

After removing my dash to replace the AC Evaporator core. Got everything put back together and now my 4x4 controls don't work, passenger side airbag seems to not to be on. All wire harness seems to be all connected back together.

Did I missed a ground wire somewhere?

These are the codes I am getting.

 

[alrock]

The only thing I can think of is a bent pin or perhaps a wire terminal backed out of a connector

Sent from my SM-N986U using Tapatalk

 

[Jeepwalker]

The only thing I can think of is a bent pin or perhaps a wire terminal backed out of a connector

That is quite possible. I have a yellow connector on my roof airbag (the intermediate wire at the base of the b-pillar by the floor), which used to back out, till I put a piece of dense foam behind it (so it couldn't). Also, if it backs out at the airbag itself there's a shunt (small piece of metal wire) that shorts between the airbag connectors when the connector is removed. The idea is to prevent arcing and an accidental airbag deployment when servicing the airbag system. If that shunt didn't fully push 'in' the airbag module could read a 'short' in the wiring (the shunt making a short). So look carefully at the connector on the airbag-side ...that the shunt is fully pushed 'in' when the connector is installed.

 

[StandoutAlpha]

Turns out I had 2 wires mismatch plugged in wrong. Now its back to normal and working again.