ridge demon slider frame brackets???

[silvrzuki77]

Hey guys, I know ridgedemon is on hiatus at the moment and I dont know if anyone has contact with him. My question is or would he be willing to sell just the frame mounts for the sliders kind of like a DIY kit or could get me in contact with him to work something out. Like a group buy of the brackets for those who are able to build there own and obviously a percentage or something would go to brodi for his work. I know his sliders are the best there were!!!!! I am looking at building something a litte wider for more of a step and protection. I am not trying to offend brodi or anything like that!!! I understand R&D aspect and time put into it. The options of good sliders as you guys know now suck.
Thanks
chris

 

[3Hummers]

I think Brodie may be overseas.

 

[silvrzuki77]

Thats the last i heard also. Hoping someone might have better contact with him.

 

[reaper]

He is overseas, and more than likely wouldn't be able to help you from there. I passed it on to him via facebook though!

The rocky roads have a little bit of a step and stick out a few inches... I could send you pics or measurements if you like.

 

[silvrzuki77]

Thanks for passing my request on to him! I had built a set off sliders some what like the rockyroads (square tube frame brace's) for my old h3. i think round tube is the way to go with my H3T. Harder to setup round tube but less deflection when using the slider on stuff. At least that was my experience when i built my rock buggy. Thanks for the help!

 

[machineguneddie]

Anybody else making the frame reinforcement plates.


Should be working, But on my iPhone using Tapatalk

 

[machineguneddie]

Planning on ordering a winch mount this weekend


Should be working, But on my iPhone using Tapatalk

 

[Bigunit]

I just sent Brodie an email asking him about both items. Let's see if he replies - I'll let you know what he says if he does.

 

[kflips]

let me know if you do not get a response. I might be able to get to him in one fashion or another.

 

[silvrzuki77]

Thanks guys for the help. We could easily reproduce both those parts if there is an intrest an brodi is interested.

He is overseas, and more than likely wouldn't be able to help you from there. I passed it on to him via facebook though!

The rocky roads have a little bit of a step and stick out a few inches... I could send you pics or measurements if you like.

 

[reaper]

Ok, I got this back from Brodie:

I know the CB photo is making the frame plates now. As for the brackets on the sliders they would have to wait until I got home. They would have to understand that they are made slightly larger than needed so when they fit onto the jig I made I had material to remove to make a perfect fit over having to add. The gussets for them can be purchased from places on the internet. If they can wait till I get home I can look into it more. I only get 3 weeks home but I'll do what I can. I'll be home Nov. 5th.

If you have requests for Brodie, I'd queue them up over on this thread http://www.hummer4x4offroad.com/forum/showthread.php?1830-Ridge-Demon-information

 

[silvrzuki77]

I just saw the reply, thanks for getting in touch with him for me. I understand what he means. I think that if he did make a bracket kit he would be able to sell a bunch. Im going to have to make my own in the next couple of weeks since its finally getting below a 104 degrees now and its time to wheel!!!