sagging t bars.

[digglesworth]

I think my torsion bars are wearing out. I just cranked em a few months ago and I'm probably 1/2-3/4" lower than what I set them at. I've got 86k on the truck so I'm not super surprised. I'm gonna rebuild the front end probably in the fall and will most likely add the t bars to the list. But I dunno if I should get alpha bars are stay with I5 bars. I have a brushguard but no winch. A winch is a good possibility but I cant get over how much $$$ the various mounts/bumpers are. Plus the $$$ for the winch. If money was disposable to me, it would be a Thorparts front and rear... What do you guys think about the t bars. Is it common for them to sag over time (and what's considered "time")...? And alpha vs I5 with or without a winch?

 

[ABNTROOP]

Go new alpha tbars. That way new winch or no, you'll be ready for it.

 

[cgalpha08]

Id go with alpha t bars. I believe they are stiffer than the i5. If your rebuilding, might as well upgrade where you can

Sent from my SCH-I545 using Tapatalk

 

[08H3I5]

:corn:

 

[persius1]

Where's a good place to get the alpha t-bars? Mine aren't holding the height like they used to.

Sent from my XT1058 using Tapatalk

 

[Bigunit]

I'm sure Zack can source the Alpha tbars for you. Try sending him a PM.

Sent from my XT1080 using Tapataint