will it settle?

[digglesworth]

Well I feel like I'm beating a dead horse here but I just got my truck back from the shop and once again it's about 25-25.5" from the center of the wheel to the fender.... I'm gonna go drive it for a bit and bounce it around a little. Is there any harm in driving it for a day or so with it upwards of 25" or should I crank it back down right now? I'm curious to see if it'll settle any...

 

[TAPDH3T]

My truck was sitting a little high when I did mine.. It took three days for it to drop and I still had to raise it some more because of how low it dropped..

 

[06 H3]

id go down. 25 is way to high and probably will only settle to 24.5 which is still too high IMO. I would drop down to 23.5

 

[digglesworth]

I don't wanna drop it too much and have to go back up in a few days... Although, that's not the worst thing in the world.... I may go to 24 right now and see where it is in a couple days... Then when it finally does settle, I'll have to get the alignment checked again and might very well be at square one all over...

 

[SkinGripz]

Sounds like they adjusted your torsion bars when they did the alignment. I would readjust, take it back, and tell them not to touch the torsion bars.


"If at first you dont succeed, come back with a big damn stick". -My Dad
Sent from my iPad using Tapatalk

 

[digglesworth]

I'm gonna let it settle for a couple days.... I hardly drive my truck during the week... I'll adjust it after that and see where it sits... I wanted to give it some time this last time but the idiots didn't tighten all the uca bolts.....