Search results

I did a little bit of research after your last post on tcm compatibility. I'm definitely not the expert on this since I used a standalone. I think the tcm updates were mostly for ecu compatibility, not to support transmission upgrades. That said with a new flash I am pretty certain you will...

Well damn that would have saved some headache. There are two sets of switches in the stock quadrant. One set to run the prndl lights. And a second park/neutral that goes into the start circuit. I have the p/n switch wired to a relay inserted in the start circuit and a second reverse relay to...

Ok. Tap Shifting is sorted. It's pretty slick. You can dictate some specific behaviors depending on how you set up the shift tables when in TUTD mode. Most of the street guys set the table to go ahead and shift up at redline so they can TUTD to roll race gear and just mash the throttle. If...

Awesome. Thanks. I'll add it to my Amazon cart.

Alex any issues getting the shifter into D1 with this? I replaced mine with something similar from Amazon or somewhere and the leather is better quality than OEM but it's thicker and the shifter really doesn't want to go into D1. With my tap shift project I'll likely be pulling the shift knob...

Some things you may want ICT Billet cooling -AN cooling line adapter -6 AN hose and fittings I think the ECP radiator has 3/8" inverted flare fittings. Get some adapters to go to -AN lines. In think I got mine from summit. There should be enough spare hose in that kit to make a spare trail...

This is my test setup for now. If this works I may get a spare shift knob and see if I can embed these buttons in it. A second option is to use a rocker switch in position 1 like Acer4Lo did. Third option is spend money on an OEM or aftermarket shifter. It looks like Lokar is the only one...

Ok. My prndl lights do not work. The switches that fit on the quadrant for the 4l60 do not match up to the 6l80e shaft and I could not come up with an acceptable solution. I did write down the logic table of outputs for future reference if I decide to try and encode something but currently the...

I've got the buttons and the resistors. I've got a project list for the holiday weekend and may actually get to this during the weekend. Stay posted.

I need this out of my garage, taking up space and I've moved on from the 4L60e. It's a bastardized unit modified to mate to my 4BT. If I recall there are some hummer specific bits that may be getting hard to find and that's where there may be some value to someone looking to hoard some spare...

Finally got my intercooler project wrapped up. I started last fall chasing down an oil leak which turned into a missing gasket when I assembled the seal retainer plate. As I was about to work on that under the vehicle I spotted a broken motor mount. That repair was much easier done with the...

First pic kinda blurry because I was moving. Knocked this out on my last tank. Too bad diesel is still 40-60% more expensive than gas for no unexplained reason. 20.00 gallons for a 21.4 MPG average.

For $0 cash and I'll pay the shipping. I need one for an intercooler mockup.

CaseyS submitted a new Showcase Item: 2006 Hummer H3 Read more about this showcase item here...