H3 Crossmember Bushing Center

[USMC_TOP]

Ok I know that we have people here that rebuild the crossmember with a poly bushing but I am cheap right now as I spent 3 k last month fixing up my truck. New t case, fuel pump, front and rear axel seals, cam position sensor, rear breaks etc. what I am asking is does anyone have the part number they are using to buy the bushing or the width and length necessary so I can replace my own? I can figure out the washers needed myself I just want to buy one bushing and fix it myself. Thank you for your time gents.


Sent from my iPhone using Tapatalk

 

[JPaul]

From my understanding there isn't a good, easy, long-term, cheap fix for the diff bushing. If you can afford the couple hundred for it I would go with the Outfitter Design kit that replaces the main diff bushing and the support bracket bushings. I think it is the cheapest best solution if you want to fix it just once.

Sent from my Nexus 7 using Tapatalk

 

[justin94tt]

I have the polyurethane bushing, washer, and grade 8 bolt you need. I had installed on my last H3, and removed it prior to trade in. I will send it to you if you pay shipping. PM me if you are interested.

 

[USMC_TOP]

I have the polyurethane bushing, washer, and grade 8 bolt you need. I had installed on my last H3, and removed it prior to trade in. I will send it to you if you pay shipping. PM me if you are interested.

Heck yes I will!


Sent from my iPhone using Tapatalk

 

[USMC_TOP]

Got the bushing installed a couple weeks ago and that diff does not move anymore at all! I hope it's ok mounted solid like this with 0.0 up and down play.


Sent from my iPhone using Tapatalk

 

[justin94tt]

It will be good to go, the bushing I sent you is polyurethane not delrin so it will be able to flex a very small amount.