• Welcome to H4O! For a reduced ad experience, please login or register with the forum.

New with question...

n8rfastback

Well-Known Member
Messages
89
Location
Omaha, NE
So my H3 is slipping going into reverse, only sometimes. Going from park to reverse it'll get kind of jerky and I can feel it trying to grab, hitting the gas only makes it slip worse. Most of the time it doesn't do it.

Any ideas? Forward gears are never an issue. 2007 H3, 127,000 miles. Automatic, obviously.

Any help is appreciated.

Nate

Sent from Nates phone...
 

n8rfastback

Well-Known Member
Messages
89
Location
Omaha, NE
No it's not the pawl, it comes out of park fine, just slips trying to go into reverse...
Almost like you have it in reverse and are feathering the clutch and letting it just barely grab, but not enough to move you backwards...

Sent from Nates phone...
 

DJinCO

Well-Known Member
Google search revealed the following:

Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell. It is possible to remedy a fluid problem by removing the checkball from its cage in the case in the rear of the transmission may help (must remove valve body), or adding a high-viscosity additive or other seal restorer product. May also have worn boost valve (can replace in the pan).
 

4speedfunk

Well-Known Member
Messages
4,250
Location
Tardville
Check the fluid level first. Slipping in reverse, (especially before its up to operating temperature) is very common in ALL GM automatics, when the fluid gets low. Sometimes its just low fluid...sometimes something more. But for the cost (free)...checking the level is a no-brainer. Make sure you check it properly:

Drive it around for a 1/2 hour then park it on a level slab.
Let it sit and idle for five minutes.
Then check the dipstick several times, while the motor is running and AT is in "PARK".
 
Top