Torsion bar removal for cat converter

[Xscorex]

I see that I have to remove my torsion bar to remove the exhaust pipe that has the 2nd cat converter in it. How do I do that? I havent found any DIYs. Is this something I will need a special tool to do?

 

[rascole]

1. Measure for hub to fender distance first and foremost. WRITE IT DOWN.
2. Lift the front end off the ground. This takes all the weight off of the torsion spring/bar.
3. Remove the torsion adjustment bolt, 26 mm socket, at the rear of the bar. Remember how many turns so you will have a reference for re-installation.
4. The bar will now slide out backwards and out of the front pocket in the lower control arm.

 

[Xscorex]

Thanks. That doesnt sound so bad. Is tbere a trick for re assembly?

 

[rascole]

When it is all back together, leave the passenger side about half inch higher to account for settling and check after a few trips around the block.