H3 JKS 2001 Sway Bar Links

[bubbas3rd]

Does anyone have a picture of these installed on H3 with 4 in Rancho lift????


Sent from my iPhone using Tapatalk

 

[rascole]

LOL, I have a few. They work great and highly recommend them.

 

[rascole]

Here is a link to a video showing how the suspension moves freely when the front and rear are disconnected.
https://youtu.be/DSDQzne5pWg

 

[bubbas3rd]

Awesome! Mine did not come with 2 pins…and the screws they sent were too short since I’m not using the bracket! Guess I will order more pins and clips!! You have been a great help, as always!!


Sent from my iPhone using Tapatalk

 

[rascole]

Awesome! Mine did not come with 2 pins…and the screws they sent were too short since I’m not using the bracket! Guess I will order more pins and clips!! You have been a great help, as always!!


Sent from my iPhone using Tapatalk

Yes, I should said that, I ordered 2 extra pins and clips.

 

[bubbas3rd]

Bare with me…just a girl trying to figure this stuff out…what part is this, and could I fix it on my own?? This just happened….


Sent from my iPhone using Tapatalk

 

[Guerrero]

LOL, I have a few. They work great and highly recommend them.
View attachment 27590
View attachment 27591
View attachment 27592

Awesome!! Do you know of these for H3 in stock height? I want to install it in my H3 alpha

Thank you!

 

[Gpcalero]

Bare with me…just a girl trying to figure this stuff out…what part is this, and could I fix it on my own?? This just happened….


Sent from my iPhone using Tapatalk

Bubbas3rd,

I believe the lower ball joint you are using is an AC Delco Professional piece. I have found that those come with a greasable zerk fitting that has clearance issues with the cv boot. You should clean up the grease in that area and check the clearance between the zerk fitting and the cv boot first. If it is hitting then you will need to replace the fitting with a low profile fitting and give it a pump of grease, as well as replace the cv axle OR the boot if the axle isn't destroyed. You can certainly do this yourself, but I would have somebody help you who knows what they are doing for your first time.

I ran into this issue while installing my Rancho and was replacing the upper and lower joints while I was in there. Luckily, I noticed the issue before putting the truck on the ground. If that is the case, then you oughta be upset with whoever replaced the balljoint.

 

[Gpcalero]

Awesome!! Do you know of these for H3 in stock height? I want to install it in my H3 alpha

Thank you!

Oscar,

I run these on my Alpha as well. All you should do is measure your existing links and buy a JKS end link that is adjustable to that length. I think the Rancho uses 4" end links. Not sure about stock ones.