Low Profile Ball Joint Zerks (Homemade)

[Jeepwalker]

This is what happens when ya have too much time to waste!!

Ok, there are probably some low profile zerks avail for 59 cents somewhere, but I couldn't find any ...so I made a couple that'll keep a comfortable gap between the joint and the axle boot.

Cheers

 

[Traxx]

If you get the correct ball joints with the zerk in the right spot it saves alot of frustration.

 

[JPaul]

I was worried about mine as well, I used the same ones you did. In the end I found there wasn't an issue with clearance, but you do need to make sure to get the fitting pointing the right direction. I found it best to put the zerk on first, then install the ball joint so that I could make sure it was pointing the right direction.

Sent from my SM-N950U using Tapatalk