• Welcome to H4O! For a reduced ad experience, please login or register with the forum.

H3 Oil light

samiamakasamuel

Active Member
Messages
31
Location
Kershaw
I have a 06 Hummer h3 when I’m driving it and stop at a light or park the rpms drop enough to cause the oil light to come on. What do I need to check.


Sent from my iPhone using Tapatalk
 

mjferencak

Well-Known Member
Messages
308
Location
Elbert, CO
Check your oil level first. Your oil sensor could be bad. Worst case scenario your oil pump is going out.


Sent from my iPhone using Tapatalk
 

amrg

Well-Known Member
Messages
2,317
Location
Qatar
You will need to Remove entire engine to do that (I did)

Before you do that try the following steps,

1. Check oil level
2. Replace oil and filter and new sensor at the same time. Do an engine flush too
3. If it comes back, try seafoam

If all didnt work, engine out.

I tryed step 1 and 2, repeated step 2 three times. After the engine was out and opened, it turned out that an Oil bypass valve was stuck open causing low oil pressure when hot. It had alot of sludge and only needed cleaning.




Sent from my SM-G920F using Tapatalk
 
Last edited:

08H3

Well-Known Member
Messages
1,370
Location
United States
Pull the plug off the sending unit. If it's bad, you'll see oil. First indication on mine was a frantic phone call from my wife screaming the oil light is on while on 465 in Indianapolis.
 

mjferencak

Well-Known Member
Messages
308
Location
Elbert, CO
There are various concoction to an engine flush. It involves pouring a concoction in with the oil and running the engine for a few minutes or miles and draining the oil mixture. Some people use seafoam, some use mystery oil, some even use diesel and kerosene.


Sent from my iPhone using Tapatalk
 

rascole

Well-Known Member
Messages
2,852
Location
Bellflower, CA
Does it continue to idle low for a long duration when you stop or is it a momentary drop then climbs back up? If it is momentary then clean your MAF and check your spark plugs, they may be fouled and need to be replaced. All very easy to do.
 

JPaul

Well-Known Member
Messages
2,436
Location
Way up north, UT
Mass Air Flow sensor, it's the sensor that is screwed onto the inlet pipe just next to the air box.

Sent from my SM-N950U using Tapatalk
 

JPaul

Well-Known Member
Messages
2,436
Location
Way up north, UT
Get a can of electronics cleaner at Walmart or AutoZone or something, remove the screws holding the sensor in place, pull it out and blast it really well with the cleaner, then put it back.

Sent from my SM-N950U using Tapatalk
 
Top