Jeepwalker
Well-Known Member
- Messages
- 980
- Location
- WI
Dumb question but are the oem u-joints held in with resin ...or just clips? I haven't dug into mine yet.
Thanks!
Thanks!
-
Welcome to H4O! For a reduced ad experience, please login or register with the forum.
U-joint Question
- Thread starter Jeepwalker
- Start date
JPaul
Well-Known Member
- Messages
- 2,436
- Location
- Way up north, UT
Clips on both the front drive shaft and the rear drive shaft. Never seen u-joints held in with resin before. Front driveshaft uses c-clips inside the ears, rear driveshaft as the outer clips.
Jeepwalker
Well-Known Member
- Messages
- 980
- Location
- WI
Thanks! Good to know.
Resin bonding was something GM used to do. Not sure when they got away from it (90's?? ..ha, ha). It sure held them in tight. Clips are easier to work with. Vehicle was at the shop so I couldn't look at.
cheers..
Resin bonding was something GM used to do. Not sure when they got away from it (90's?? ..ha, ha). It sure held them in tight. Clips are easier to work with. Vehicle was at the shop so I couldn't look at.
cheers..
Last edited: